127-73 CLUTCH, DRIVER - RESPONSE / BIGFOOT - ARGO ATV PARTImportant! Before Ordering Read Notes Below
Fits Argo Atv Models:
Response 8x8Bore Size:
If you are using this clutch to replace an older powerbloc clutch you must drill out the bore to accept the old 7/16" bolt. May also require spacer 114-04 for clutch alignment.
If replacing clutch 126-54 with the new 127-73 the tolerance of the clutch fins on the new clutch may hit the engine block. Be sure to order 1 # 114-04 shim washer to move the clutch away from the engine block. Do not start the engine to check if the clutch fins hit the engine block, turn clutch by hand with the clutch bolt tight. You will also need (1-2) 108-36 shims for the secondary clutch to match the offset on the primary clutch shim.